Anleitungen, Informationen, "how to's"... (von User für user!)
Moderatoren: mohni, muskote, lilredridinghood
- 440 Magnum
- Beiträge: 2729
- Alter: 45
- Registriert: 10. September 2006, 10:46
- Wohnort: 67...
Yes they do work and you will get more postive caster.
If you installed them like the instructions in the package they might not help you much.
The Moog intention of the bushings are for rusty cars that have sagging frames that bend inward over time.
The "trick" is to install them like this diagram below and ignore the Moog instructions.
s will be pointing opposite directions front bushing to rear bushing.
First make sure you set the ride height first to what you want.
Factory manual alignment specs are no good for radial tires, they only work if you use bias-ply tires.
For Radial tires, Camber -.50 to 0 degrees, Caster as much positive as you can get up to 3 degrees and toe in 1/16th to 1/8th inch.
Car runs down the road straight as an
now. You will be limited to what you can do with stock A arm bushings, but if you have the Moog off set A arm bushing you can tweek it a little more.
- 426 Super Stock
- Beiträge: 6142
- Alter: 55
- Registriert: 2. Januar 2004, 13:44
- Wohnort: Berlin
Nur für Diagonalreifen
Wer ist online?
Mitglieder in diesem Forum: 0 Mitglieder und 2 Gäste